 |
|
DiscountCompParts.com is your online resource for all things computer, bringing you a wide selection of hard drives, cables, networking equipment,
printer cables, USB cables, adapters, computer accessories, and much much more...all at everyday discount prices! So if you are looking for high quality
computer spare parts that fits well under the budget, the Discount Computer Parts Center is the perfect place for you! |
 |
|
|
|
|
Fiber, SC-ST, Multi-Mode Duplex, 3M
Type: Multi-Mode, Duplex.
Fiber Size: 62.5/125 micron.
100% Inspected and tested.
Durable Strain Relief.
Item #: DCP-SC-ST-3M
Price: $ 9.10
|
| |
|
|
PRODUCT SPECIFICATIONS |
|
|
|
|
SC, square, keyed connector with push-pull mating 2.5mm ferrule and molded housing for protection.
ST, cylindrical with twist lock coupling, 2.5mm keyed ferrule. For both short distances applications and long line systems.
Fiber cable construction (riser rated) must be in compliance with the following specifications: TIA/EIA-568A; Bellcore GR-409; UL OFNR/FT4; Max attenuation: 3.5/1.5 dB/km (850/1300nm); Min Bandwidth: 400/400 MHz Km; Operating Temperature: -20C~70C; Storage Temperature: -40C~70C.
Insertion loss shall be no greater than 0.3dB when tested in accordance with TIA-455-171-A method D1. Reference quality launch connectors and adapters are optional. Testing shall be performed at a wavelength of 1300 +/- 30nm.
The corresponding insertion and return loss for each connector shall be glued to the data label in the packaging.
Min. Bending Radius: 6cm (loaded); 3cm (unloaded).
Connector durability shall be in accordance with TIA/EIA-455-21A. Maximum change of O.2dB after 200 insertions. The connectors in this assembly shall meet the intermareability requirements of TIA-EIA-604-2.
Non-contact dust caps shall be installed prior to packaging to protect ferrule endface.
Termination shall not have visible scratches or chips within the core area at a magnification of 200X.
The notaion "XXXX" within the part number shall identify the overall length from ferrule up to ferrule tip as shown. The units of measure are indicated by the character position immediately following the "XXXX" portion of the part number.
The plactic jacket and aramid yam of the cable shall be captured by the crimp ring and shall conform to the cable retention.
Data label shall be glued on the center of the bag. Its front is facing toward us. It should be of the same angle as the text on the bag.
The tolerance of jumper length below 5 meters is 0 to 25 cm, for longer than 5 meters is 0 to 40 cm.
|
|
|
|
|
|
|
|
 |
|
|
|
